How To Install The Tiny But Mighty Modifier on the IceLight3 in Under 60 Seconds

The Tiny But Mighty Modifier easily installs onto the  RGB Ice Light 3 from Westcott and the  bi-color LED Ice Light 3 in under 60 seconds. The installation instructions and video tutorial can be found below.

  1. Slip a reflector sleeve onto each barn door. If you find it difficult make sure you at the top and the bottom you only insert a little of the barn door into the sleeve. It should be a very snug fit.
  2. Assemble your IceLight3 with both barn doors on.
  3. Raise both barn doors until they are vertical.
  4. Place the channels of the diffusion panel over the top edge of each of the barn doors. Slide it down until it is all the way in on both barn doors.
  5. Open the barn doors until they are each at approximately a 45 degree angle and the diffusion material is taut.
  6. You are now ready to use your IceLight with the Tiny But Mighty Modifier.
  7. When you are done with the lights you can choose to store the reflector sleeves on the barn doors or you can take them off.

Scroll to Top